







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Pinewood, FL: What It Costs and What It Takes
Asphalt driveway paving in Pinewood typically runs $3,500 – $9,000, and a full resurface of an existing drive usually lands in the same window depending on square footage and how much base repair is needed. Most residential driveways here are finished in two to three days: one day to prep and grade, one day to place and compact, and a return visit for sealcoat once the asphalt cures. Call (844) 797-4868 for a free on-site measurement and a written, line-item number before any work starts.
How an Asphalt Driveway Gets Built in Pinewood, Start to Finish

Asphalt isn’t poured like concrete. It’s placed hot, compacted in lifts, and it depends entirely on what’s underneath it. That’s why the first day is almost all dirt work, and why skipping that step is the number one reason Pinewood driveways fail early.
Stage 1: Site visit, measurement and utility check (day 1, about 60 – 90 minutes)
We walk the drive, measure square footage, check slope and drainage direction, and mark any irrigation lines, cable runs or sewer cleanouts. If your drive crosses a swale or connects to a county right-of-way, that gets flagged here. You’ll decide the width you want (a standard single-car apron is 10 – 12 feet; a double is 20 – 24 feet) and whether you’re widening, extending or replacing in place.
Stage 2: Demolition and excavation (day 1 – 2, 4 – 8 hours)
Old asphalt, broken concrete or failed base material comes out and gets hauled off. We excavate to a depth that fits the compacted base course, typically 4 – 6 inches of limerock or crushed aggregate under 2 – 3 inches of asphalt for a residential drive. On Pinewood’s mid-century lots, this is also when we find out what’s under the old surface: root systems from mature ficus or oak, old paver base, or a slab that was never properly drained.
Stage 3: Grading, base compaction and drainage (day 2, 3 – 5 hours)
The base gets graded to a minimum 2% slope away from the structure and compacted in lifts with a plate or roller. Standing water is the enemy of asphalt in South Florida’s wet season, so this is where the job is won or lost. You’ll want to be available for a quick look at the grade before we proceed if the drive ties into a garage slab or a drainage swale.
Stage 4: Hot-mix asphalt placement and rolling (day 2 – 3, 3 – 6 hours)
Hot mix arrives by truck, gets spread with a paver or by hand for tight residential work, then rolled to density while it’s still hot. Edges get squared and compacted. We typically place two lifts on a residential drive: a base lift and a finish lift, which is what gives you a smooth running surface and better resistance to cracking.
Stage 5: Cure, seal and final walkthrough (day 3 to week 4, plus a return visit)
You can walk on new asphalt within 24 hours and drive on it in about 48 – 72 hours, but full cure takes weeks. Sealcoat goes down after cure, usually a few weeks to a couple months later, and then on a recurring cycle. At the final walkthrough you get the written scope, the care instructions, and your 730-Day Done Right Promise in hand. If anything isn’t right, we make it right.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Blacktop or Something Else? The Choices That Shape Your Driveway
Asphalt is one option among several, and the honest answer is that it isn’t right for every Pinewood lot. Here’s how the choices actually compare, so you can decide before you’re standing in a driveway listening to a sales pitch.
- Hot-mix asphalt (the standard choice). Lowest installed cost of the hard surfaces at roughly $3,500 – $9,000 for a residential drive, flexible enough to handle minor settlement, and repairable. Downsides: it fades to gray, needs sealcoat every 2 – 3 years, and softens in extreme heat. Best for homeowners who want a clean, functional surface at a reasonable price and are willing to maintain it.
- Concrete. Runs $4,500 – $12,000 for the same footprint. Longer lifespan, no sealing cycle, cooler underfoot. But it cracks, and in South Florida’s sun-and-rain cycle it cracks more than most people expect. Best when you want minimum maintenance and don’t mind the higher upfront cost.
- Pavers. Highest end of the range, best curb appeal, and individual units can be lifted and reset if something settles underneath. Best for homeowners planning to stay long-term or who want the driveway to match a paver patio or walkway.
- Resurface vs. full replacement. If the existing asphalt is structurally sound with no alligator cracking or base failure, an overlay resurface can be the smarter spend. If the base has failed, an overlay just buys you a year or two.
- Sealcoat. A maintenance line item, not a repair. It protects against UV and water intrusion, and skipping it is the fastest way to shorten the life of a new asphalt drive in this climate.
If the driveway is part of a larger exterior project, we can fold it into the bigger scope as part of a full Driveway & Pavers in Pinewood plan, and homeowners often pair this with Chain Link Fence in Pinewood work when they’re redoing the property line at the same time.
What Asphalt Driveways & Resurfacing Costs in Pinewood, FL

Plan on $3,500 – $9,000 for asphalt paving on a typical Pinewood residential driveway, and $5,000 – $14,000 if you’re removing and replacing the whole drive including base work. Resurfacing an existing sound drive usually comes in at the lower end of the paving range.
Here’s the line-item breakdown we put in writing:
| Line item | Typical range |
|---|---|
| Asphalt driveway paving (new) | $3,500 – $9,000 |
| Full driveway replacement (demo + base + asphalt) | $5,000 – $14,000 |
| Driveway sealing (maintenance) | $250 – $700 |
| Concrete driveway, for comparison | $4,500 – $12,000 |
| Paver driveway, for comparison | $7,000 – $18,000 |
The four things that push a job toward the high end:
- Square footage. A 400 sq ft single-car apron and a 900 sq ft double-wide drive are two very different jobs. Width and length drive material and labor almost linearly.
- Existing condition. A sound drive that just needs an overlay is the cheapest. A drive with base failure, root intrusion or a cracked slab underneath means demo, haul-off and new base, which is where the number climbs.
- Drainage and grading. If the lot is flat or the drive slopes toward the garage or the house, we may need to build in a French drain, swale or corrective grade. That adds labor and material.
- Access and staging. Tight side yards, carports still in place, or a driveway that requires hand-work because a truck can’t reach it all add cost.
- Permit scope. Work that touches the county right-of-way or changes the curb cut pulls in permitting; simple replacement inside the property line typically doesn’t.
Every written estimate lists what’s included (demo, haul-off, base, compaction, asphalt, cleanup) and what isn’t (sealcoat timing, drainage amendments, right-of-way permitting). Upfront pricing, no surprises: the number you see is the number you pay.
See the difference
Before
After
Before
After
Before
AfterWhy Pinewood Driveways Are a Different Job
The first surprise for most people is who governs the work. Pinewood, ZIP 33167, sits in Miami-Dade’s inland northwest corridor in unincorporated county land, so construction runs through Miami-Dade County’s e-permit system and private provider inspections rather than a separate city hall. For a driveway, that matters when the work touches the right-of-way or drainage; for anything structural nearby, it matters a lot more because every job here falls under High Velocity Hurricane Zone product-approval rules.
The second surprise is the ground itself. Pinewood’s housing stock is mid-century CBS construction on cinderblock-and-concrete lots, often with carports, mature trees and original driveways that have been patching along for years. On those lots the original base is usually thin, the drainage was never designed for a modern wet season, and tree roots from old ficus and oak plantings have had decades to work their way under the surface. We regularly see alligator cracking that traces straight back to a root system the homeowner never knew was there.
And the climate does the rest. Subtropical South Florida means intense UV that bleaches and oxidizes asphalt, and a May-through-October wet season that turns every low spot into a puddle. A driveway built for a drier climate fails here in five to seven years. One built with proper grade, base and a sealcoat cycle holds up much longer.
We cover all of Pinewood and the surrounding corridor, and if your project also touches power, water or a new structure, homeowners often pair this with ADU Site Prep & Utilities in Pinewood so the driveway and utilities get planned together instead of back-to-back.
Serving Pinewood, FL – Our Local Coverage Area
We serve Pinewood and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Asphalt Driveways & Resurfacing in Pinewood

Most Pinewood asphalt driveways are completed in two to three working days, with sealcoat applied weeks later once the asphalt cures. Demo and grading are the long poles; placement and rolling go fast on a residential-sized drive. Call (844) 797-4868 for a schedule estimate tied to your specific drive.
Often no, sometimes yes. If the work stays inside your property line and replaces an existing drive in the same footprint, a residential asphalt overlay or replacement usually doesn’t trigger a building permit. Work that changes the curb cut, touches the right-of-way, or alters drainage can require Miami-Dade County approval. We tell you up front which side of that line your job falls on, and we handle the paperwork if a permit is needed.
Yes, if the existing asphalt is structurally sound with no base failure, alligator cracking or major settlement. A resurface (overlay) skips demolition and places new asphalt over a cleaned and prepped surface. If the base is shot, an overlay is a short-term fix that fails early. We’ll tell you honestly which one you need, with the reasoning, before you commit.
Resurfacing typically runs $3,500 – $9,000 depending on square footage and prep, and full replacement with new base runs $5,000 – $14,000. Factors include how much surface prep is required, whether any base repair is needed, and access. Call (844) 797-4868 for a free on-site quote with exact numbers for your drive.
Every job we do is covered by the 730-Day Done Right Promise, one of the longest workmanship guarantees in residential construction. If something isn’t done right, we make it right. Our technicians have up to 12 years of experience, arrive in uniform, and are background-checked. Finishing at the high end of the range includes our recommended sealcoat schedule so the drive stays protected through its first Pinewood wet season.
Get Your Asphalt Driveway Estimate in Pinewood
Call (844) 797-4868 to schedule a free on-site estimate for asphalt driveways & resurfacing in Pinewood. A live person answers, 24/7, and we’ll set a time that works for you. On the visit, we measure the drive, walk the base and drainage, and hand you a written line-item quote on the spot. If the driveway is part of a bigger project, our Driveway & Pavers service team can scope it alongside the rest. We look forward to walking your property with you.
Written by the team at Groundwork Construction Co.












