







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Miami Beach, FL: What the Job Actually Involves
Door installation in Miami Beach typically takes one to three days per opening and runs $1,200 to $4,800 for a standard exterior door, more when the existing frame has to be rebuilt or the door is impact-rated. The work means removing the old slab and frame, repairing whatever the opening reveals, setting a plumb new frame, hanging and adjusting the door, and sealing it against wind-driven rain. Call (844) 797-4868 and we’ll walk you through what your specific opening needs before anyone shows up with a truck.
How We Run a Door Installation, Stage by Stage

Every opening is different, but the sequence doesn’t change much. Here’s what actually happens once we’re on site.
Stage 1: Open the wall and see what’s behind it
Removing the old door takes an hour or two. The real information comes when the frame comes out. In Miami Beach’s older concrete-block and stucco buildings, that’s often where we find rusted lintels, spalled block, or a rough opening that’s out of square by half an inch. We photograph everything and show you before we quote the repair. This is the decision point where you approve or decline the structural work.
Stage 2: Repair and prep the opening
A day of framing, shimming, and blocking, longer if the rough opening needs to be rebuilt or a rusted steel lintel replaced. You decide here whether to replace the frame entirely or reskin it. Replacing costs more and lasts longer. Reskinning is faster and cheaper but only makes sense when the existing frame is solid and the fasteners haven’t given up.
Stage 3: Set and hang the door
Four to six hours for a standard pre-hung unit. We shim the frame plumb, anchor it, set the hinges, and adjust the strike plate until the door swings and latches without a fight. You check the swing direction and hardware before we move on. This is also when impact-rated units get their specific anchoring sequence, which is not the same as a standard door.
Stage 4: Seal, flash, and waterproof
This stage matters more in Miami Beach than almost anywhere. Wind-driven rain probes every joint, and a door that looks fine can leak at the threshold or the head for years. We flash the opening, seal with marine-grade sealant, and add a door pan or threshold detail where the grade or exposure calls for it. Half a day, and it’s the difference between a door that lasts and one you’ll be recaulking every spring.
Stage 5: Inspect, adjust, and hand off
If the job requires a permit, a city inspector signs off on the installation before we call it done. We do a final swing test, check the weatherstripping contact, and leave you with the hardware adjustment instructions. Callback issues in the first week are almost always a hinge or a strike plate, and we handle those without a question.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Real Choices You’ll Make: Door Materials and Spec
Most of this job comes down to four decisions. Here’s what to weigh.
- Fiberglass vs. steel vs. wood. Fiberglass is the best fit for salt air, since it won’t rust or rot and holds a stain well; you’ll pay more for it. Steel is cheaper but dents and will rust at any scratch if the finish isn’t maintained. Solid wood looks the part but needs repainting every few years in this humidity.
- Impact-rated vs. standard. In Miami Beach’s hurricane zone, impact-rated doors are often required for new or replaced openings. They cost 30 – 60% more than a comparable standard door but eliminate storm panels and lower your insurance premium.
- Pre-hung vs. slab. Pre-hung (frame and slab together) is the norm for a full replacement and runs less labor. A slab replacement keeps the existing frame and is cheaper, but it only works when the frame is truly sound.
- Hardware and finish. Stainless or hot-dipped fasteners are non-negotiable within a few blocks of the ocean; galvanized will fail years sooner. Door hardware finishes matter too – a marine-grade sealant and a good threshold pull their weight more than a fancy handle.
We specify from brands we trust, including Andersen and Marvin for doors rated for this climate, so the material spec matches the exposure.
What Door Installation Costs in Miami Beach, FL

Door installation in Miami Beach generally runs $1,200 to $4,800 per opening for a standard exterior door, and $2,800 to $7,500 for an impact-rated unit with a new frame. Interior doors are a fraction of that. Five things push a job toward the high end:
- Existing frame and opening condition. A rusted lintel or spalled block adds $600 to $2,000 in repair work that no one can price until the frame is out.
- Impact rating. Required in most of Miami Beach’s wind-borne debris region, and it carries a real premium over a standard unit.
- Door size and configuration. Oversized, sidelighted, or double doors cost more in material and labor.
- Permit and inspection scope. A permitted replacement carries the city’s review and inspection fee, which is part of the estimate.
- Exposure and waterproofing detail. A door facing the ocean or a wind-driven rain elevation needs a more involved flashing and sealing sequence.
Your written estimate is line-itemed: door and frame, hardware, labor, waterproofing, permit, and any repair allowance. What isn’t in the estimate is structural repair we can’t see until demo, and we flag that in writing rather than surprise you later. The number you see is the number you pay on the work we quoted.
See the difference
Before
After
Before
After
Before
AfterWhat Miami Beach Homes Do to This Job
The housing stock is the story here. Much of the low-rise building in 33139 is 1920s-to-1940s Mediterranean Revival and Art Deco masonry, and by now the door frames in those buildings have seen decades of salt air and humidity. We regularly open a frame in the Art Deco core and find a rusted steel lintel or spalled concrete block that has to be repaired before a new door will sit plumb. In the 1950s-to-1970s mid- and high-rise stock from South Beach up through 33140 and 33141, the issue is usually the original door itself: worn out, out of spec, and due for an upgrade to an impact-rated unit. Gated estates on North Bay Road and the Venetian Islands see the same salt-driven hardware failure, just on a bigger scale.
On top of that, Miami Beach is a barrier island, so flood-plain rules and the city’s coastal building code come into play on openings at grade. Within a few blocks of the ocean, galvanized fasteners fail years sooner than on the mainland, so we spec stainless or hot-dipped hardware and marine-grade sealants as a matter of course. In the historic district, exterior changes to a door require design review, so a replacement can add weeks to the schedule. That’s why we price the permitting reality into the quote up front rather than discovering it mid-job. You can see how this fits into a full Windows & Doors in Miami Beach scope, and if your project touches the rest of the envelope, our windows & doors service handles the rest.
Serving Miami Beach, FL – Our Local Coverage Area
We serve Miami Beach and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked: Door Installation in Miami Beach

A standard exterior door takes one to three days, longer if the frame needs structural repair or the job is in the historic district and requires design review. Impact-rated units with a new frame can stretch to four or five days once permitting and inspection are factored in. Call (844) 797-4868 for a timeline specific to your opening – estimates are free.
Yes, most exterior door replacements in Miami Beach require a permit, and impact-rated replacements almost always do. The city’s coastal building code and flood-plain rules mean the review goes beyond a simple replacement check. We pull the permit and pass the inspection as part of the job. Call us to confirm the scope for your specific address.
Yes, in most cases a door replacement is a like-for-like swap within the existing opening and doesn’t touch plumbing or structure. The exceptions are when the rough opening has deteriorated or the existing frame has shifted, which we identify during demo. If structural repair is needed, we show you before we proceed and quote it separately.
Standard exterior door installation runs $1,200 to $4,800 per opening, and impact-rated units with a new frame run $2,800 to $7,500. The range depends on door size, frame condition, impact rating, and permit scope. Call (844) 797-4868 for a written line-item estimate – the consultation is free.
Every door installation we do is covered by our 730-Day Done Right Promise: if it isn’t done right, we make it right. That covers our workmanship on the install, not the door manufacturer’s product warranty, which we hand over with the job. Call (844) 797-4868 for the details before you book.
Get Your Door Installation Priced in Miami Beach
If you’re pricing a door replacement or an upgrade at a Miami Beach address, the next step is a free on-site estimate. We’ll look at the opening, measure it, check the frame condition, and hand you a written line-item quote with a clear price. Call (844) 797-4868. A live person answers, day or night. We cover Miami Beach and the surrounding neighborhoods, and if the project grows into a broader scope, homeowners often pair it with Cabinets & Countertops in Miami Beach or a Garage Conversion ADU in Miami Beach.
Written by the team at Groundwork Construction Co.












