







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Door Installation in Opa-locka, FL: What the Job Actually Involves
Exterior door installation in Opa-locka, FL typically runs $1,800 to $6,500 for a single standard-sized door, and we usually have the old door out and the new one hung, sealed, and trimmed in one day. That price covers removing the existing slab and frame, addressing whatever rot or settling sits behind it, installing the new unit plumb and square, and finishing the perimeter so it survives hurricane-season rain. Interior passage doors are cheaper, often $450 to $1,500 each. Call (844) 797-4868 for a free on-site estimate – the exact number depends on what’s behind your current door.
How Door Installation Works, Stage by Stage

Door Installation isn’t a “measure and screw it in” job, especially in Opa-locka’s older concrete-block and stucco homes. Here’s the real sequence we follow, and where you make the calls.
Stage 1: Measure and site check (day 1, about an hour)
We measure the rough opening, check the wall for plumb and square, and look for the failures older homes hide – cracked stucco around the frame, a sill that’s settled, or a header that’s moved. You decide then whether you’re replacing the slab only or the full frame, and that choice changes the job and the price more than anything else.
Stage 2: Confirm the door and the spec (day 1-2)
You pick the material, the swing direction, the hardware, and the glass package if it’s an exterior door. This is where the timeline stretches, because most orders for a non-stock exterior door take 2 to 5 weeks to arrive. We write the spec into the quote so what shows up is what you approved.
Stage 3: Demolition and prep (install day, 2-4 hours)
We cut out the old door and frame, then get a hard look at the opening. In Opa-locka’s concrete-block walls, that often means patching chipped block and re-flashing the threshold. Rot or termite damage in the framing around the opening is common and can add a few hours – you’ll know before we proceed, not after.
Stage 4: Set, shim, and seal (install day, 2-3 hours)
The new door goes in, gets shimmed and checked for square, and is anchored. We foam the gaps, tape the flashing, and seal the exterior perimeter. This stage is the one that decides whether the door leaks in a driving rainstorm, so it’s not the part to rush.
Stage 5: Hardware, trim, and final walkthrough (install day, 1-2 hours)
We hang the door on its hinges, install the lockset and any deadbolt, add the interior and exterior trim, and check that the door swings, latches, and seals properly. You walk it with us before we call it done. If it’s part of a larger project, this is the point where it ties into a full Windows & Doors in Opa-locka scope.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of what a homeowner wrestles with on Door Installation is picking the material and config. Here’s the honest trade-off on each, in plain terms.
- Fiberglass (exterior entry): $2,200 – $5,500 installed. Holds up best to South Florida sun and humidity, won’t rot, and takes paint or a wood-grain stain finish. The right default for most Opa-locka homes.
- Steel (exterior entry): $1,800 – $4,800 installed. Strong and secure, but dents, and rust is a real problem if the finish fails near the coast. Best for a back door or service entrance.
- Solid wood (exterior entry): $2,500 – $6,500 installed. Beautiful, matches the historic look, but needs annual upkeep in this climate. Suits a restored property more than a working door.
- Impact-rated glass options: add $400 – $1,500 to any of the above. Worth it in a hurricane zone if the door has glass; the hardware and frame also need to be rated to match.
- Interior doors: $450 – $1,500 installed. Hollow-core is cheapest and lightest; solid-core is quieter and feels better in a bedroom. Pick based on where the door sits and how often it gets used.
Door material and glass is where the big-box stores stop and real product lines start. We work with proven brands like Cover for entry systems and Dvele for high-performance units where the spec calls for it, so you’re choosing quality, not just what’s on the shelf on a Saturday.
What Door Installation Costs in Opa-locka, FL

A single exterior door installed in Opa-locka runs roughly $1,800 to $6,500. That’s a wide range, and here’s what pushes a job to the low end versus the high end.
- Slab vs. full frame: replacing just the door leaf is the cheapest path; replacing the whole frame (often necessary in older homes) adds $400 – $1,200.
- What’s behind the old door: sound framing means a clean install; rot, termite damage, or a settled header can add $300 – $1,500 in repair.
- Material and glass grade: fiberglass and impact glass cost more than a basic steel slab, but hold up better here – see the options above.
- Size and opening type: a standard 36-inch door slots into a standard opening; a wide or custom size means custom framing and a custom order, both of which raise the number.
- Permit scope: a like-for-like door swap in an older home sometimes needs no permit; a change in the door’s size, location, or impact rating may trigger one, which adds permit fees and inspection scheduling.
Your written estimate lists the door model, the frame scope, hardware, sealing, permit status, and labor separately – so you see exactly what’s in it. What’s typically not included is interior painting, and any structural repair that only becomes visible after demolition; we quote that separately once we’ve opened the wall, before we do it.
See the difference
Before
After
Before
After
Before
AfterWhat Opa-locka Homes Specifically Do to This Job
Opa-locka is unlike neighboring cities in one big way: it holds the largest concentration of Moorish Revival architecture in the Western Hemisphere, with dozens of 1920s buildings featuring domes, minarets, and ornate arched stucco around every opening. That matters for Door Installation because the openings aren’t standard. Many of the older homes and outbuildings in the 33054 ZIP carry arched or unusually shaped entry doors, heavy ornate trim, and original stucco-on-masonry walls – so a door replacement here is often a detail-matching job, not a straight swap. We’re regularly matching an original arch profile or repairing the stucco around a frame that has been baking in South Florida sun and taking wind-driven rain for decades.
Outside the historic core, the mid-century and older concrete-block homes in 33054 and 33055 tend to have original door frames and sills that have settled, and thresholds that have taken on water. Hurricane-season rain and high humidity are hard on exterior doors and trim, so rot around the sill and bottom rail is a common find. If your door is part of a bigger whole-house change – say you’re also reworking the kitchen or adding a separate living space – this job often pairs with Cabinets & Countertops in Opa-locka or a Garage Conversion ADU in Opa-locka that needs its own exterior entry. We cover all of Opa-locka and the surrounding area.
Serving Opa-locka, FL – Our Local Coverage Area
We serve Opa-locka and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Door Installation in Opa-locka

Installation day is typically 4 to 8 hours for a single exterior door, from demo through the final walkthrough. The long lead time is almost always material: a stock-sized door installs fast, while a custom or non-stock door takes 2 to 5 weeks to arrive after you approve the spec. Call (844) 797-4868 and we’ll give you a realistic timeline for your exact door.
It depends on scope – a like-for-like replacement of the same size door often doesn’t need one, while changing the opening size, location, or impact rating may require a permit and an inspection. We handle the permit question as part of your estimate and tell you upfront whether your job needs one and what it adds. Call (844) 797-4868 to talk through your specific door.
Usually yes, if the new door matches the existing opening size. A straight swap – same rough opening, same swing – avoids any structural change and is the cleanest, most predictable job. A wider or arched opening that has to match the historic Moorish Revival profile means custom framing, so the scope grows; we’ll show you which situation you’re in before quoting.
Expect roughly $1,800 to $6,500 for a single exterior door installed, and $450 to $1,500 per interior door. The number moves with the material, glass grade, whether the frame is replaced, and any rot or stucco repair we find behind the old door. Call (844) 797-4868 for an exact quote – estimates are free.
Every Door Installation we do is covered by the 730-Day Done Right Promise – if it’s not done right, we make it right. That’s one of the longest workmanship guarantees in the residential construction space, and it’s stated in writing before we start. Call (844) 797-4868 to schedule a free estimate and see it in person.
Get a Free Door Installation Estimate in Opa-locka
Whether you’re replacing one failing entry door or a set of them across an older Opa-locka home, we’ll come out, measure the opening, look at what’s behind the frame, and hand you a written estimate with the door model and labor broken out. No-hassle upfront pricing, a free design consult, 0% financing for 18 months, and $1,000 off projects over $10,000. Call (844) 797-4868 – a live person answers, any hour.
Written by the team at Groundwork Construction Co.












